KBS Coatings50001 Gloss Black System Sampler, KBS Klean (8oz.), Rust Blast (8oz.)and Rust Seal (8oz.)

Got this for my scooter that the tank rusted out internally. Cleaned it out as suggested with this product, and nearly your later I'm still driving around on my scooter just fine. No problems at all shocked actually. I was kind of skeptical but it is what it says it is and then some. As I don't believe it was supposed to be used internally as I did in the gas tank. So that being said, I definitely would use it again. Was a little bit time-consuming processes. Took about a day and a half for full cure which I would say was well worth the wait. People saying that it didn't set, just didn't give it a chance and or follow the instructions correctly.

Followed directions. Seems to be holding up well. Paint is like a tough plastic coating when dry.Impossible to keep paint from solidifying in the can though. Even covering with plastic wrap before replacing lid did not work. Plan ahead to use as much of the paint at one time as possible.I had to throw away over half of the paint because I could not use it all right away.BTW -- humidity causes it to cure. We have a weather-tight garage with a dehumidifier and the paint still skinned over quickly.

slow shipping

Easy enough to use as it sealed a rusty surface.

i used this on a flat metal surface which i was able to sand and smooth out - works great in that situation...but you may experience what others have in applying the coating over an uneven, coarse, bumpy type of surface.In this case you may get those, erupting bubbles, that others have mentioned. So in short, the product works great on even and smooth surfaces, and unpredictable on coarse rusty surfaces......so difficult to say whether i would recommend or not.....just not sure

It is a little early to tell, but it seems like it will do the job okay.Probably will knowmore in a couple of years or so. Not that it makes any difference as it is on mybeater truck, but still I don't like to see rusted out places. My job is not perfectbut still looks alot better than before, even using rattle can paint.

Used this on my son's Jeep Liberty after repairing some rust holes. It's gone through one heck of a winter and still looks good.

Covered the top of my 42" tractor mower deck. Be sure to wear glove and eye protection when applying. Got pait on fingers when removing gloves. Looks like the specks will be there when they bury me.Hope it sticks to the mower deck as well.

My 2 older vehicles, an’03 Windstar and an ‘07 Trailblazer, were beginning to show their age with rust developing on the seam between the inner and outer panels at the bottom of all doors . I checked the internet as to recommended products for this task and found the KBS Coatings system as a recommended product. I was extremely happy when I found this product available on Amazon. Between the packaged instructions, the company’s internet videos and my trusty rotary tool, I was able to complete the job in relatively short order. The job looks great and I don’t think I will bothered by rust again at these spots for quite some time.

super bon produit. il y a 1 ans j'ai fai reparation sur mon rouilleux ford escape et ca tuffer malgrer le sel des route au quebec,

looking forward to using it